Shop

Glass Clip

Swiss Glass clips hold glass, matboard, print and backing board together to provide a inexpensive, classical minimal look with no further frame required.

Sand the glass to remove sharp edges before installation.

Trim boards neat and tidy to provide a sharp clean cut look

Make a small hole in the backing board for the prong to sit into and slide the clip over the cut and cleaned glass and backing layers.

Three sizes available:

1. 30mm clip length x 9mm height x 8mm width. Holds 7mm combined material thickness.            1st + 2nd image
2. 39mm clip length x 12mm height x 13mm width.  Holds 11mm combined material thickness. 3rd+4th image
3. 30mm clip length x 13mm height x 12mm width. Holds 10mm combined material thicknes. 5th+6th image

With each of the above sizes only the small 3mm wide prong is visible on the front of the glass, all of the measurements above indicate the clip material behind the backing board.